AMECON 5306 Search Results

AMECON 5306 Result Highlights (5)

Part	Manufacturer	Description
P82530-6	Rochester Electronics LLC	Multi Protocol Controller, 2 Channel(s), 0.1875MBps, NMOS, PDIP40, DIP-40
D82530-6	Rochester Electronics LLC	Multi Protocol Controller, 2 Channel(s), 0.1875MBps, NMOS, CDIP40, DIP-40
TP82530-6	Rochester Electronics LLC	Replacement for Intel part number TP82530-6. Buy from authorized manufacturer Rochester Electronics.
EL5306IUZ	Renesas Electronics Corporation	350MHz Fixed Gain Amplifiers with Enable
EL5306IUZ-T7	Renesas Electronics Corporation	350MHz Fixed Gain Amplifiers with Enable

AMECON 5306 Datasheets Context Search

Catalog Datasheet	MFG & Type	Document Tags	PDF
Amecon 5306 Abstract: No abstract text available Text: gflMECON THE ENERGY SAVER FOR 2 3 YEARS 30A CURRENT TRANSFORMER, P /N 5306 ELECTRICAL SPECIFICATIONS PRIMARY CURRENT: TURNS RATIO: VOLT PER AMP RATIO AT 30 A, FOR 100 OHM LOAD: VOLT PER AMP RATIO AT 3 .0 A, FOR 100 OHM LOAD: D.C.RESISTANCE AT 20‘ C DIELECTRIC WITHSTANDING VOLTAGE:	OCR Scan	025IN Amecon 5306	PDF
Amecon 5304 Abstract: Amecon 5306 Text: gflM ECD N iv T ' THE ENERGY SAVER <57# . FOR 23 YEARS APPLICATIO W ith this circuit an alarm will sound when the current sensed by the C T falls outside a pre-set range. The range is set by adjusting the potentiometer P such that the op-amp will invert at any required current level.	OCR Scan	LM3914 Amecon 5304 Amecon 5306	PDF

Catalog Datasheet

MFG & Type

Document Tags

PDF

Amecon 5306

Abstract: No abstract text available
Text: gflMECON THE ENERGY SAVER FOR 2 3 YEARS 30A CURRENT TRANSFORMER, P /N 5306 ELECTRICAL SPECIFICATIONS PRIMARY CURRENT: TURNS RATIO: VOLT PER AMP RATIO AT 30 A, FOR 100 OHM LOAD: VOLT PER AMP RATIO AT 3 .0 A, FOR 100 OHM LOAD: D.C.RESISTANCE AT 20‘ C DIELECTRIC WITHSTANDING VOLTAGE:

OCR Scan

025IN Amecon 5306

PDF

Amecon 5304

Abstract: Amecon 5306
Text: gflM ECD N iv T ' THE ENERGY SAVER <57# . FOR 23 YEARS APPLICATIO W ith this circuit an alarm will sound when the current sensed by the C T falls outside a pre-set range. The range is set by adjusting the potentiometer P such that the op-amp will invert at any required current level.